Internal Usb Key - Dell PowerEdge M820 Owner's Manual

Figure 13. Replacing the SD Card
1. SD card 1
3. management riser card
5. SD card slot identification label

Internal USB Key

The blade provides an internal USB connector for a USB flash memory key. The USB memory key can be
used as a boot device, security key, or mass storage device. To use the internal USB connector, the
Internal USB Port option must be enabled in the Integrated Devices screen of the System Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and
then specify the USB memory key in the boot sequence in the System Setup. For information on creating
a bootable file on the USB memory key, see the user documentation that accompanied the USB memory
key.
Replacing The Internal USB Key
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To avoid interference with other components in the blade, the maximum allowable
dimensions of the USB key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Remove the blade from the enclosure.
2. Open the blade.
3. Locate the USB connector / USB key.
4. If installed, remove the USB key.
2. SD card 2
4. USB connector
41