System Connections; Connecting/Using A Stereo System; Specifications - JVC HR-S6970AG Instructions Manual

System Connections

Connecting/Using a Stereo System

These instructions enable you to connect your video recorder to
your Hi-Fi stereo system (if you have one) and listen to the
soundtrack through the stereo.
FM Tuner
CD Player
Stereo Amplifier
I
Television
Speaker Speaker
Mains
outlet
Make Connections
Connect the AUDIO OUT L and R connectors on your video
recorder to the AUX IN or TAPE MONITOR terminals on your
stereo system's receiver or amplifier.
NOTES:
When connecting your recorder's audio output connectors to a
stereo amplifier, make sure you connect L and R correctly.
If stereo or bilingual TV broadcasts are receivable in your area,
this recorder can record them independently of the TV set and
play them back through the connected stereo system.
When listening to sound through the connected stereo system,
turn the TV's volume down completely.
CAUTIONS
This recorder has a dynamic range of more than 80 dB with
regards to its Hi-Fi audio capability. It is recommended that you
check the maximum level if you are going to listen to the Hi-Fi
audio signals through a stereo amplifier. A sudden surge in the
input level to the speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do
not place the speakers adjacent to the TV set as this can
adversely affect the video playback picture.
AUX IN or TAPE MONITOR
Audio Cable
(not provided)
AUDIO IN

Specifications

GENERAL
Power requirement
Rating
Operating
Power consumption
(For HR-S6970AG)
Power on
Power off
(For HR-S6970AJ)
Power on
Temperature
Operating
Storage
Operating position
Dimensions (W x H x D) : 400 mm x 94 mm x 275 mm
Weight
Format
Maximum recording time
(SP)
(LP)
(EP)
Rear View
VIDEO/AUDIO
Signal system
Recording system
Signal-to-noise ratio
Horizontal resolution
S-VHS
VHS PAL/MESECAM : 250 lines
VHS NTSC
Frequency range
Normal audio
Hi-Fi audio
Input/Output
TUNER/TIMER
TV channel storage
capacity
Tuning system
Channel coverage
VHF
UHF
Aerial output
Memory backup time
ACCESSORIES
Provided accessories
* Not provided in certain area
Specifications shown are for SP mode unless otherwise specified.
Design and specifications subject to change without notice.
— 19 —
: AC 110 V – 240 V , 50 Hz/60 Hz
d
: AC 90 V – 260 V , 50 Hz/60 Hz
d
: 18 W
: 3.5 W
: 20 W
: 5°C to 40°C
: –20°C to 60°C
: Horizontal only
: 3.1 kg
: S-VHS/VHS standard
: 240 min. with E-240 video cassette
(PAL/MESECAM)
: 160 min. with T-160 video cassette
(NTSC)
: 480 min. with E-240 video cassette
(PAL/MESECAM)
: 720 min. with E-240 video cassette
(PAL/MESECAM)
: 480 min. with T-160 video cassette
(NTSC)
: PAL-type colour signal and CCIR
monochrome signal, 625 lines/
50 fields
: NTSC colour and EIA monochrome
signals, 525 lines/60 fields
: DA-4 (Double Azimuth) head helical
scan system
: 45 dB
: 400 lines
: 220 lines
: 70 Hz to 10,000 Hz
: 20 Hz to 20,000 Hz
: RCA connectors:
IN x 2, OUT x 1
S-Video connectors:
IN x 2, OUT x 1
: 99 positions (+AUX position)
: Frequency synthesized tuner
: (Low) 42 MHz – 175 MHz/
(High) 175 MHz – 470 MHz
: 470 MHz – 870 MHz
: UHF channels (Adjustable E28 – E60)
: Approx. 10 min.
: RF cable,
S-Video cable,
Infrared remote control unit,
"R6/UM-3" battery x 2,
Conversion plug*