Auto Sp Lp Timer; Repeat Playback; Ntsc Playback - JVC HR-S6600EK Instructions Manual

Auto SP LP Timer

If, when timer-recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-
minute tape
Approximately 150 minutes
SP mode
Total 210 minutes
Make sure you set "AUTO SP LP TIMER" to "ON" at the Mode
Set screen before the timer-recording starts.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS MODE SET
SCREEN
2
Press %fi to move the highlight bar (pointer) to "MODE
SET", then press OK or
SELECT MODE
3
Press %fi to move the
highlight bar (pointer) to
"AUTO SP LP TIMER",
#
then press OK or
"ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTES:
The Auto SP LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 or with some tapes
of shorter lengths.
If you have programmed the recorder to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set "AUTO SP LP TIMER" to "ON". In
this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
In order to ensure that the recording fits on the tape, this
feature may leave a short non-recorded section at the end of
the tape.
There may be some picture noise and sound disturbance at
the point on the tape where the recorder switches from SP to
LP mode.
If you perform timer recording with both PDC and the Auto
SP LP Timer activated, and the programme goes beyond its
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
Approximately 60 minutes
LP mode
#
.
MODE SET
B. E. S. T.
PICTURE CONTROL
to select
AUTO TIMER
O. S. D.
DIRECT REC
AUTO SP=LP TIMER
POWER SAVE
NEXT PAGE
[5∞] =
[MENU] : EXIT

Repeat Playback

Your video recorder can automatically play back the whole tape
50 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ( ) on the display panel blinks
slowly.
The tape plays 50 times automatically, and then stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

NTSC Playback

ON
AUTO
OFF
Your video recorder is equipped with NTSC circuitry that can
ON
ON play back NTSC tapes.
ON
OFF
LOAD A CASSETTE
1
Insert a cassette recorded in NTSC.
START PLAYBACK
2
Press PLAY.
"NTSC PAL" appears on the screen for about 5
seconds.
Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
The counter and tape remaining time readings will be
incorrect.
During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
37