Procedure Overview - Panasonic KX-TDA30 Installation Manual

2.7.2 Procedure Overview

2.7.2 Procedure Overview
When connecting the wireless system, use extreme care in conducting the site survey. Site surveys can be
conducted using the KX-TCA255/KX-TCA256/KX-TCA355/KX-TD7590 PS. An incorrectly performed site
survey can result in poor service area, frequent noise, and disconnection of calls.
1. Investigate the installation site
Refer to "2.7.3 Site Planning".
a.
Obtain a map of the CS installation site.
b.
Identify the service area required by the user on the map.
c.
Plan the location of each CS, taking account of distance, building materials, etc.
2. Prepare for site survey
Refer to "2.7.4 Before Site Survey".
a.
Check and assign the CS ID number to the PS.
b.
Assign a channel number to each CS by setting the DIP switches on the back of the CS.
c.
Supply electricity to each CS using an AC adaptor/battery box or by connecting them to a Super Hybrid
Port or a DLC card.
d.
Install each CS temporarily as planned.
Note
•
Install at least 2 m above the floor.
•
Keep the antennas in the upright position.
3. Conduct the site survey
Refer to "2.7.5 Site Survey Using the KX-TCA255/KX-TCA256/KX-TCA355/KX-TD7590".
a.
Test the radio signal strength using the PS.
Confirm that the radio signal strength level is "12" near the CS.
Using the KX-TCA255/KX-TCA256/KX-TCA355
Press 1, 9, and POWER
for more than 2 seconds.
Using the KX-TD7590
Press 1, 9, and POWER
for more than 5 seconds.
b.
By walking away from the CS with the PS, check the radio signal strength. The radio signal strength
weakens as you walk away from the CS.
c.
Map the CS coverage area at radio signal strength levels "3" and "8".
124 Installation Manual
Display example:
To survey
specific channel
RADIO STRENGTH
<<< MEASURING >>>
Channel No.
0 to 9
To survey
specific channel
Display example:
RADIO STRENGTH
Channel No.
<<< MEASURING >>>
0 to 9
RADIO STRENGTH
CH0 SLOT:06 SYNC
L:12 0000/0100
CS-ID:9005301234
CH0 SLOT:06 SYNC
L:12 0000/0100
CS-ID:9005301234