Edit From A Camcorder - JVC HR-J677MS Instructions Manual

Edit From A
Camcorder
1
4
7
NUMBER "0"
1
Recorder
VIDEO IN AUDIO IN
AV Cable (not provided)
VIDEO OUT
Camcorder AUDIO OUT
EDIT
Player
2 3
2
5 6
8 9
4
0
PR +/–
Your recorder
To the remote PAUSE
connector
Editing Cable
(not provided)
You can use a camcorder as the source player and your video
recorder as the recorder.
MAKE CONNECTIONS
1
Connect the camcorder's AUDIO/VIDEO OUT connec-
tors to the recorder's front panel AUDIO/VIDEO input
connectors.
Use the L connector for monaural connection.
When a Master Edit Control-equipped JVC camcorder
is used, the camcorder is capable of controlling the
recorder. Refer to the camcorder's instruction manual
for operating procedure.
SET RECORDER'S INPUT
MODE
2
Press NUMBER key "0" and/or PR+/– so that "F-1"
appears on the display panel.
SELECT "EDIT" FOR PICTURE
CONTROL SET MODE
3
Follow the "Picture Control" section on page 15, then
select "EDIT."
START CAMCORDER
4
Engage its Play mode.
START RECORDER
5
Engage its Record mode.
NOTES:
All necessary cables can be obtained from your dealer.
You can also use another video recorder as the player instead
of a camcorder.
When you select "EDIT" to dub tapes in step 3, be sure to
select "AUTO" (or "NORM" when B.E.S.T. is set to "OFF") after
you finish dubbing the tapes(
IMPORTANT:
To edit, both the player and the recorder must be of the
same colour system. Press your recorder's COLOUR
SYSTEM button to select the appropriate colour system.
PAL, SECAM and NTSC camcorders can be used as a
player for editing.
For more information on multi-system compatibility,
pg. 38.
37
EN
pg. 15).