TP-Link Archer C5 Quick Installation Manual

Quick

Installation Guide

AC1200 Wireless
Dual Band Gigabit Router

1. Connecting the Hardware

1 Power off the modem,
and remove the backup
battery if any.
Power Off
INTERNET
Note: If your Internet comes via an Ethernet cable from the wall instead of any DSL/Cable/Satellite modems, please connect the Ethernet cable directly to the router's Internet port.
2. Configuring the Router
Method 1 Via Web Browser
1
Connect your computer to the router (Wired or Wireless).
Wired
Wireless On/Off USB1 USB LED USB2 Internet 1 2 Ethernet 3 4
2
Open a web browser on the computer and configure the router according to the following main clues.
a
Enter http://tplinklogin.net in the address bar.
http://tplinklogin.net
c
Choose the frequency you prefer and then click Next.
Quick Setup-Wireless Dual Band Selection
Concurrently with 2.4GHz and 5GHz (802.11a/b/g/n/ac)
Only work in 2.4GHz (802.11b/g/n)
Only work in 5GHz (802.11a/n/ac)
Back
2 Connect the modem to the
Internet port on your router using
an Ethernet cable.
LAN
WPS/Reset
Ethernet cable
Type in admin for both the user name and password
and click OK.
Note: If the login window does not appear, please refer to FAQ->Q1.
d
Click Next to continue.
You may rename your 2.4GHz/5GHz wireless network name and
create your own password. Once done, the wireless connection will
disconnect automatically, and you must then sign in with the new
names/passwords to regain access to the Internet.
2.4GHz & 5GHz Wireless Network Name and Password
Wireless Network Name:
Next
Modem
Typical Connection
3 Power on the modem,
wait for 2 minutes and
then power on the router.
INTERNET
Wireless
Connect wirelessly by using
the default network name
Or
(SSID) and password on the
product label printed on the
bottom of the router.
admin
admin
OK Cancel
TP-LINK_XXGHZ_XXXXXX
Region:
Warning:
Wireless Security:
PSK Password:
XXXXXXXX
Back Next
INTERNET
4 Check the following LED
lights to ensure the hardware
connection is correct.
Power On
INTERNET
Power System
On Flashing
Note: If the 2.4G and 5G LEDs are not flashing, please verify
that the wireless switch on the rear panel of the router is on.
Power On
b
Select your Connection Type and if you are unsure what your
connection type is, select Auto-Detect. Click Next and follow
the instruction to continue.
Note: If an Internet connection is already established, the Quick Setup
b
wizard will bypass Step and go to Step
Quick Setup-WAN Connection Type
Auto-Detect
Dynamic IP (Most Common Cases)
Static IP
PPPoE/Russian PPPoE
L2TP/Russian L2TP
PPTP/Russian PPTP
Back
e
Click Finish to complete the setup.
Quick Setup-Finish
Congratulations!
Back Finish
2.4G 5G Internet
Flashing Flashing On/Flashing
c
.
Next
Enjoy!
Now your wired and
wireless devices can
connect to the Internet !