Settings For Hdmi - Sony DAV-JZ8888K Operating Instructions Manual

Note
• You cannot change the color system of the disc itself.
• You can change the color system of this system
according to the connected TV (page 15).
x [BLACK LEVEL]
(North American, Mexican, and Latin
American models only)
You can select the black level (setup level) for
the video signals output from the jacks other
than COMPONENT VIDEO OUT/HDMI OUT.
[ON]: The standard level.
[OFF]: You can lower the standard black level.
Use this when the picture becomes too white.
x [BLACK LEVEL (COMPONENT OUT)]
(North American, Mexican, and Latin
American models only)
You can select the black level (setup level) for
the video signals output from the
COMPONENT VIDEO OUT jacks.
You cannot select this and the setting is not
effective when the system outputs a progressive
signal.
[OFF]: You can set the black level of the output
signal to the standard level.
[ON]: You can raise the standard black level.
Use this when the picture becomes too black.
x [PAUSE MODE] (DVD VIDEO/DVD-R/
DVD-RW only)
You can select the picture in pause mode.
[AUTO]: The picture, including subjects that
move dynamically, is output with no jitter. This
setting is for normal usage.
[FRAME]: The picture, including subjects that
do not move dynamically, is output in high
resolution.
50
GB

Settings for HDMI

[HDMI SETUP]
HDMI SETUP
HDMI RESOLUTION:
CONTROL FOR HDMI:
VOLUME LIMIT:
YC C /RGB(HDMI):
B R
AUDIO(HDMI):
JPEG RESOLUTION:
x [HDMI RESOLUTION]
You can select the type of video signal that is
output from the HDMI OUT jack. For details,
see "To select the type of video signal output
from the HDMI OUT jack" (page 24).
[AUTO (1920 1080p)]: The system outputs
×
the optimal video signal for the connected TV.
[1920 1080i]: The system outputs 1920 ×
×
1080i* video signals.
[1280 720p]: The system outputs 1280 ×
×
720p* video signals.
[720 480p]**: The system outputs 720 ×
×
480p* video signals.
* i: interlace, p: progressive
** Depending on the area, [720 × 480/576p] may
appear.
x [CONTROL FOR HDMI]
You can set the [CONTROL FOR HDMI]
function to on/off. This function is available
when you connect the system and TV with an
HDMI cable. For details, see "Using the Control
for HDMI Function for "BRAVIA" Sync"
(page 59).
[ON]: On. You can operate mutually between
components that are connected with an HDMI
cable.
[OFF]: Off.
x [VOLUME LIMIT]
If you change the output method of the TV to the
system speakers via the TV menu (or by
pressing THEATRE), the System Audio Control
AUTO
(1920x1080p)
ON
LEVEL2
YC C
B R
OFF
SD