JVC HR-J245EE Instructions Manual page 23

1
4
7
2
1
¶
1
3
OK
AUTO SP/LP TIMER Indicator
NOTES:
The Auto SP/LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 as well as some
tapes of shorter lenghs.
Even if, in step 1, you press AUTO SP/LP TIMER and it lights
up, that doesn't mean that the recorder will automatically
change from SP to LP (or EP) mode during the course of the
recording. Watch the tape later to confirm.
If you have programmed the recorder to timer-record 2 or
more programs, the second programme and those thereafter
may not fit on the tape if you engage the Auto SP/LP Timer
mode. In this case, make sure the mode is not engaged, then
set the tape speed manually during timer programming.
There may be some noise at the point on the tape where the
recorder switches from SP to LP (or EP) mode.
2 3
5 6
8 9
WEEKLY
0
TIMER
3 ¡
7 8
4 ¢
2
q 5/8
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
Repeat steps 1–8 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
9
Press TIMER. The recorder turns off automatically.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key "9") for weekly serials or DAILY (NUMBER key "8") for
daily serials (Monday–Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
NOTES:
You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
In case of a power failure after programming, the recorder's
memory backup keeps your selections (if the lithium battery is
not exhausted).
Auto SP/LP Timer (HR-J448EE
only)
If, when recording in SP mode, there is not enough tape to
3
record the entire programme, the recorder automatically
switches to LP mode (with PAL broadcasts) or EP mode (with
6
NTSC broadcasts) to allow complete recording.
ENGAGE AUTO SP/LP
TIMER
1
Press AUTO SP/LP TIMER on the recorder front panel.
The AUTO SP/LP TIMER indicator lights up.
For Example . . .
Recording a PAL-broadcast program of 210 minutes in
length onto a 180-minute tape
Approximately 150
minutes
After the recorder's Timer mode is engaged, make sure
the AUTO TIMER SP/LP indicator is still lit; if not, press
AUTO TIMER SP/LP so that the indicator lights.
pg. 24).
Approximately 60
minutes
SP mode
Total 210 minutes
23
EN
LP mode