Audio - Icy Box IB-MP3012 series Manual

http://www.icybox.de
Media Player and DTV Receiver
The possible resolution for each TV system is listed below. Select the right resolution according to the capability
of your TV set.
TV system & Resolution
nTsC
Pal
Only HDMI and YPbPr connection can output HD TV picture. Refer to the details below.
5.2.4.4 HDMI Connection
When the HDMI is connected, this device can detect the available resolution of TV set. After entering the video setup page,
the available resolution will be shown in white character and the negative one will be in dark character.
5.2.4.5 HDMI Auto
When HDMI is connected, you can choose this option to use the maximum resolution of TV set. If it is in dark character
and can't be selected, re-plug the HDMI cable and re-enter this page to try again.
5.2.4.6 YPbPr
The maximum resolution of YPbPr is 1080i. Select 50 Hz or 60 Hz according to TV system.
5.2.4.7 CVBS
The SD video will always output from this port no matter what resolution you selected.
note: When connecting lCD monitor via DVI to HDMI converter, the player will detect the support resolution
of lCD monitor. only the supported resolution (white characters) can be selected.
5.2.4.8 1080P 24HZ
Select "On" to enable this option. When this option is on, the player will output 1080p 24Hz video when the condition
below is all fulfilled:
The video output of this player is HDMI.
The EDID (Extended Display Identification Data) sent by the TV set through HDMI indicated the support of 1080p 24Hz
display.
The frame rate of the video file is 23.976 fps or 24 fps.
5.2.4.9 Movie Preview
Turn off this option to disable the preview of the movie file in the file browse window.
5.2.4.10 Resume Play
Turn off this option to disable this function. The default is enabled and the video playback progress is saved when stop and
can be continued next time.

5.2.5 Audio

Select this option to open the detail setting for the audio playback. There are four kinds of digital audio output, and can
be roughly divided into two categories "HDMI" and "SPDIF". For the HDMI, it is recommended to connect HDMI output to
HDMI receiver or TV set. For the SPDIF Only, it is recommended to connect SPDIF receiver.
5.2.5.1 HDMI LPCM (2CH)
When connecting the HDMI to TV set directly, select this option for the correct audio. The player transcodes the Multi-
channel audio data into stereo digitized analog audio (Linear pulse code modulation) and output through HDMI port.
5.2.5.2 HDMI LPCM (Multi CH)
When connecting to the HDMI receiver, select this option for the multichannel LPCM audio. If the audio is multi-channel
LPCM like LPCM 7.1, select this option to multichannel LPCM audio.
5.2.5.3 HDMI RAW
When connecting to the HDMI receiver, select this option for the multichannel audio. The player bypasses the digital au-
dio such as Dolby Digital AC3 or DTS through HDMI port. Please be aware of that the additional HDMI receiver is required
to decode and output the digital audio.
IB-MP3012 series
Standard Definition
NTSC, 480p
PAL, 576p
20
High Definition
720p@60Hz, 1080i@60Hz, 1080p@60Hz
720p@50Hz, 1080i@50Hz, 1080p@50Hz