If you performed Auto Channel Set (
built-in clock is also set automatically. The Auto and Manual
clock setting procedures are necessary when . . .
– a power outage of more than 3 minutes occurs.
– the tuner has been set manually.
– the user desires to set the clock slightly ahead of the actual time.
– the clock was not set even after Auto Tuner Set was performed.
Whether you perform Auto or Manual clock setting, you can
use the convenient Just Clock function.
The Just Clock function provides accurate time keeping through
automatic adjustments at regular intervals, by reading data from
a PDC signal.
The Just Clock option appears in the Clock Set and Auto Clock
Set screens, and can be set "ON" or "OFF" (the default setting is
"ON"). Press OK until the Just Clock setting begins blinking,
then press PUSH JOG%ﬁ to change the setting.
IMPORTANT: If you turn off Just Clock off, the accuracy of your
recorder's built-in clock may be reduced, which could
adversely effect timer recording.
Both Auto and Manual clock setting procedures begin from step 3.
TURN THE RECORDER ON
ACCESS CLOCK SET
Press CLOCK on the
remote control. The Clock
Set screen appears.
Auto Clock Set
At the Clock Set screen,
press PUSH JOG . The
Auto Clock Set screen
appears and clock setting
If "TV.PR" isn't set to the
preset position on which
Auto Clock Set data is
appears, and then the screen from step 2 reappears.
To set "TV.PR", press OK to place the cursor next to it,
then cycle through the numbers by pressing PUSH
JOG%ﬁ until the number representing the position in
which the station transmitting clock setting data
(BBC1, BBC2, etc.) is stored appears.
pg. 8), the recorder's
01 . 01
JUST CLOCK: ON
[ ]: AUTO CLOCK SET
[5 ∞ ]:ADJUST =
[CLOCK] : EXIT
AUTO CLOCK SET
JUST CLOCK: ON
CONTINUED ON NEXT PAGE.