Picture System - JVC HR-J235EK Instructions Manual

20
B.E.S.T. Picture
System
1
4
7
RECORD
6
q
MODE
2
2 3
5 6
8 9
0
PUSH JOG
RECORDING (cont.)
The B.E.S.T. (Biconditional Equalised Signal Tracking) system
checks the condition of the tape in use during recording and
playback, and compensates to provide the highest-possible
recording and playback pictures. The default setting for both
recording and playback is "ON".
Recording
LOAD A CASSETTE
1
Insert a cassette with the record safety tab intact.
The recorder power comes on automatically.
ACCESS MODE SELECT
SCREEN
2
Press MODE. The On-
Screen/B.E.S.T. screen
appears.
CONFIRM B.E.S.T. STATUS
3
The default setting is "ON". If this is the case, go to step
4. If not, press PUSH JOG fi to place the pointer next to
"B.E.S.T.", then press PUSH JOG
CLOSE MODE SELECT
SCREEN
4
Press MODE.
START RECORDING
5
Press and hold RECORD and PLAY on the remote, or
RECORD on the recorder.
The recorder spends approximately 7 seconds
assessing the condition of the tape, then begins
recording.
When the "BEST" indicator begins blinking, that
means adjustment is complete.
Display Panel Indication
As the tape check progresses, the "– –" marks on the display
panel increase upward. Once the "BEST" indicator starts
blinking, the check is complete.
ON SCREEN : ON
B.E.S.T. : ON
[5 ∞ ]: SELECT
[ ]: ON/OFF
[MODE] : EXIT
to set to "ON".