Complete Installation - Maytag 30" (76.2 CM) ELECTRIC SINGLE AND DOUBLE BUILT-IN OVEN Installation Instructions Manual

7. Slide top end of each trim piece upward onto oven side rails.
8. Push each trim piece into place at bottom of trim.
A. Push trim into place and replace screw.
9. Use screws to attach each trim piece to oven.
10. Replace oven racks.
11. Replace oven door by inserting ends of hinges into hinge
slots in the oven frame.
12. Push hinges in as far as they will go and open the oven door.
You should feel the oven door drop into place.
13. Rotate both hinge latches back to the locked position.
14. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures.
15. Repeat for lower oven door.
16. Reconnect power.
17. Display panel will light briefly, and "PF" should appear in the
display.
18. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.
8
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Oven
1. Turn power on. "PF" should appear in the display. Turn the
selector knob to OFF and press ENTER button twice.
2. Turn knob selector to BAKE, "350F" will show on the display.
Press ENTER and look through the oven window. The top and
bottom elements should glow red.
If oven(s) does not operate, check the following:
A
3. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat, turn off the oven and contact a
qualified technician.
4. Press CANCEL and turn knob selector to OFF.
5. On double oven models, repeat steps 2-4 for the other oven.
To set the clock and other oven functions, refer to the Use and
Care Guide.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.

Complete Installation

Household fuse is intact and tight; or circuit breaker has
not tripped.
Electrical supply is connected.
See "Troubleshooting" section in the Use and Care Guide.