Pioneer XV-S100DV Service Manual page 81

Description
FL
of Error
The tray switch that had been Open mode was forcibly changed to a mode other than
F5 Tray being pushed
Open by an external force.
Loading, unloading or clamping could not be completed within a specified time (about
F8 Loading timeout
5 seconds).
The following error occured eight times.
(1) Focus ON sequence could not be completed even if more than two seconds after
FC Focus
(2) Focus IN sequence was finished, actually focus IN was not completed.
Error codes that are displayed on the FL display by using the remote control unit (Device error)
To display : ESC + DISPLAY + DISPLAY ; Location of the display : At the two digits of left of the FL display
FL Description of Error
AV1 access error
bit3=1 08 etc.
(read, write NG)
bit2=1 04 etc. MY CHIP access error
bit1=1 01 etc. SRAM access error
Causes if with a DVD
the focus ON command (to the servo DSP) was sent.
Causes if with a DVD
Causes if with a CD
Causes if with a CD
No operation or it becomes debugging
indication if the power is able to ON.
XV-S100DV
Operation of the Unit
Closes
Reverses the loading
direction. It timeout is
repeated upon retry, the
unit stops.
Stops wherever possible
then opens (stops in the
case of side B).
Operation of the Unit
81