I Rear View - Panasonic WJ-ND200 Installation Manual

I Rear View

q Network port
Connect this unit to a network compatible with 10BASE-
T or 100BASE-Tx to connect a PC/cameras via a net-
work.
w Alarm connector (ALARM, D-sub 25-pin, Female)
Connect an external device such as a sensor or a door
switch with this D-sub 25-pin connector.
e Alarm/Control connector (ALARM/CONTROL, D-sub
25-pin)
Connect a control switch with this D-sub 25-pin connec-
tor when controlling this unit using an external device,
or when controlling an alarm device such as a buzzer
or a lamp.
r Signal ground terminal (SIGNAL GND)
t Power switch (POWER)
y Power cord inlet (AC IN)
Connect the power cord to this inlet.
After connecting the power cord, fix the power cord
using the provided brace as follows.
1. Attach the provided brace to the rear panel of the
unit.
Brace (standard accessory)
12
q
w
ALARM
10/100BASE-T
ALARM/CONTROL
e
r
SIGNAL GND
ON
OFF
AC IN
POWER
y t
2. Fix the power cord using the brace as shown in the
illustration below.