Serial Number Setting - Pioneer DVD-V8000 Service Manual

1

7.5 SERIAL NUMBER SETTING

The serial number of this unit is stored in the EEPROM on the AJKB Assy. When the AJKB Assy is replaced, serial number
A
setting is also required. The remote control unit for service is used for setting.
How to set
Press ESC then the 9 key to enter Serial Number Setting mode.
B
Move the cursor to a digit where an alphanumeric is to be entered, using the REP.A or REP.B keys. Enter an alphanumeric,
using the SPEED – or SPEED + keys.
After all necessary alphanumerics are entered, press the SEARCH key. The indications shown below will be displayed. If the
C
setting is correct, press the SEARCH key again. The serial number will be written to the EEPROM.
D
To exit Serial Number Setting mode without writing the set serial number to the EEPROM, press the CLEAR key.
Note:
As a serial number, from the first to the 4th and 11th to 12th digits from the left are reserved for uppercase alphabetics only,
and from the 5th to 10th digits are reserved for numerics only.
E
F
108
1
2
DVD-V8000
2
3
3
4
4