Place the processor in the socket, making sure that it is
correctly aligned and that you do not bend or otherwise
damage the pins.
If the processor is misaligned it will not go into the socket, and any
attempt to force it will damage the processor, or the socket, or both
Move the securing lever to the locked position. Apply just
enough pressure to overcome the resistance offered by the lever.
If necessary, place the heat sink into position on top of the new
processor. The vanes of the heat sink must be aligned with the
airflow from the fan in front of the processor. Refit the clip
that secures the heat sink to the processor.
You will need to adjust the processor speed selection jumpers
on the motherboard. See the chapter 'System motherboard' for
more information about locating and adjusting jumper
If necessary replace the expansion cards you removed earlier.
Replace the system panels.
S y s t e m m o t h e r b o a r d
LS/VS660 OWNER'S HANDBOOK