To install a SIMM
The SIMM is not symmetrical. There are small notches in one end and
also slightly off centre along the connection edge, as shown above. It will
only fit into the socket one way.
Take the SIMM out of its anti-static packaging. Hold it by its
edges and avoid touching the metal contacts.
Place the SIMM in the socket at a 15
Pushing gently on its top corners, stand the SIMM upright in
the socket until the pegs of the socket engage the holes on the
SIMM and the metal clips hold both ends of the SIMM firmly
in position. Do not use excessive force.
If the SIMM will not fit easily, remove it and start again.
Repeat these steps for each SIMM you want to install.
S y s t e m m o t h e r b o a r d
LS/VS660 OWNER'S HANDBOOK
angle to the vertical.