Table of Contents
Advertisement
electrical connection
Make sure that you have an earthed power outlet
socket rated at 13 amps (minimum).
Attention!
If you use your dryer as built-in, the socket must
be reachable after installation, or a separate switch
(which can disconnect the two poles) must be used in
the installation. Check for suitability.
For a permanent connection, a master switch with
at least 3mm contact clearance and minumum 13 A
rating must be used.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency shown
in the rating label corresponds to your electricity
supply.
We recommend that this appliance be connected
to the mains supply via a suitable switched and fused
socket in a readily accessible position.
Should the mains lead of the appliance
become damaged or need replacing at any time,
it must be replaced by a special purpose made
mains lead which can only be obtained from a Beko
Authorised Service Agent.
Warning
This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off and an
appropriate plug fitted.
The moulded plug on this appliance incorporates
a 13A fuse. Should the fuse need to be replaced
an ASTA approved BS1362 fuse of the same rating
must be used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the plug must
not be used until a replacement fuse cover has been
fitted. Colour of the replacement fuse cover must
be the same colour as that visible on the pin face of
the plug. Fuse covers are available from any good
electrical store.
In order to avoid hazards, damaged supply cord
should be replaced by the manufacturer, its service
agent or similarly qualified people.
Built-under installation
This appliance can be installed under a worktop.
Only authorised specialists are permitted to car-
ry out a built-under installation. Risk of electric
shock!
Important
Fitting a different plug
As the colours of the wires in the mains lead of
this appliance may not correspond with the coloured
markings identifying the terminals on your plug,
proceed as follows:
1 Connect the green - yellow or green (earth) wire
to the terminal in the plug marked 'E' or with the
symbol
or coloured green and yellow or green.
2 Connect the blue (neutral) wire to the terminal in
the plug marked 'N' or coloured black.
3 Connect the brown (live) wire to the terminal in
the plug marked 'L' or coloured red.
With the alternative plugs a 13A fuse must be
fitted either in the plug or adaptor or in the main
fuse box. If in doubt contact a qualified electrician.
Green and yellow
N
Blue or black
Washer/dryer combination
Do not stack washing machine on top of the tumble
dryer. This would damage both appliances and
guarantees would become void. It is also unsafe to
stack an appliance on top of another without using a
suitable and approved stacking kit obtained from the
manufacturer of the appliances.
• A special stacking kit is required as an optional
extra please contact customer service.
4
or green
L
Brown or red
Hide quick links:
Advertisement
Table of Contents
