Table of Contents
Advertisement
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.
Before Installation
General
• Be sure your hands are dry.
• Turn the power off to all components.
• Read the manuals supplied with the components you are going to
connect.
Locations
• Install the receiver in a location that is level and protected from
moisture.
• The temperature around the receiver must be between –5˚ C and
35˚ C (23˚ F and 95˚ F).
• Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling the receiver
• Do not insert any metal object into the receiver.
• Do not disassemble the receiver or remove screws, covers, or
cabinet.
• Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
• Remote Control (1)
• Batteries (2)
• AM Loop Antenna (1)
• FM Antenna (1)
If anything is missing, contact your dealer immediately.
Connecting the FM and AM
Antennas
FM Antenna Connections
A
A
N N
T E
A N
7 5
F M
IA L
A X
C O
A M
A M
T
O P
E X
L O
FM Antenna
Extend the supplied FM antenna horizontally.
ANTENNA
FM 75
COAXIAL
AM
Outdoor FM Antenna Cable
LOOP
AM
EXT
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75
COAXIAL terminal as temporary measure.
B. Using the Standard Type Connector (Not Supplied)
A standard type connector should be connected to the FM 75
COAXIAL terminal.
Note:
If reception is poor, connect the outdoor antenna.
Before attaching a 75 coaxial cable (the kind with a round wire going
to an outdoor antenna), disconnect the supplied FM antenna.
A
N N
B
T E
A N
7 5
F M
IA L
A X
C O
A M
A M
T
O P
E X
L O
3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RX-7000VBK and is the answer not in the manual?
Questions and answers
mi amplificador no activa el reley de audio
The JVC RX-7000VBK amplifier may not be activating the audio relay due to the following possible causes:
1. Power Cord Not Plugged In – Ensure the power cord is properly connected to an AC outlet.
2. Speaker Signal Cables Not Connected – Check and reconnect speaker wiring if necessary.
3. Speakers 1 and 2 Buttons Not Set Correctly – Press the SPEAKERS 1 and 2 buttons properly.
4. Incorrect Source Selected – Ensure the correct audio source is chosen.
5. Muting Is Activated – Cancel muting by pressing the MUTING button.
6. Balance Set to One Extreme – Adjust the balance settings.
7. Weak FM Signal (For FM Reception Issues) – Try connecting an outdoor FM antenna or selecting a different station.
If none of these solutions work, further troubleshooting or service from a JVC service center may be required.
This answer is automatically generated
Could I plug a tablet in to one of the outputs to used for music
The JVC RX-7000VBK has audio input terminals, including composite audio (red and white RCA) and potentially other connections. If the tablet has a headphone jack or supports an audio output adapter, it can be connected to the receiver using a 3.5mm to RCA cable. This would allow music playback from the tablet through the receiver.
This answer is automatically generated
@Mr. Anderson thank you for the information if you could tell me there's two locations to plug in a subwoofer now I have a powered subwoofer how would I go about plugging that in properly