Connecting The Fm And Am Antennas - JVC RX-6020VBK Instructions Manual

Getting Started

Connecting the FM and AM Antennas

AM Loop Antenna
(supplied)
Snap the tabs on the loop
into the slots of the base
to assemble the AM loop
antenna.
If AM reception is poor, connect outdoor
single vinyl-covered wire (not supplied).
1 2
AM loop antenna connection
Connect the AM loop antenna supplied to the AM LOOP
terminals.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. (Keep
the AM loop antenna connected.)
FM antenna connection
Connect the supplied FM antenna to the FM 75 Ω COAXIAL
terminal as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable (with a
standard type connector), disconnect the supplied FM
antenna.
4
Outdoor FM antenna (not supplied)
If FM reception is poor, connect outdoor FM
antenna.
ANTENNA
FM 75
COAXIAL
AM
LOOP
AM
EXT
3
Notes:
• If the AM loop antenna wire is covered with vinyl,
• Make sure antenna conductors do not touch any other
7 5
IA L
F M
A X
C O
Supplied FM
antenna
Extend the supplied FM antenna horizontally.
remove the vinyl while twisting it as shown to the right.
terminals, connecting cords and the power cord. This
could cause poor reception.
7 5
F M IA L
A X
C O
or
Standard type
outdoor FM antenna
(not supplied)
FM antenna (supplied)