Volume, Sound Mode And Other Controls - JVC RV-B99 BK/BU Instructions Manual

VOLUME, SOUND MODE AND OTHER CONTROLS

VOLUME control
+ : Use to increase the volume.
– : Use to decrease the volume.
(Control range from VOL 0 to VOL 50.)
÷ The volume level is displayed in the display window for 2 seconds.
Main unit
VOLUME
SUPER WOOFER VOLUME control
+ : Use to emphasize the bass sound.
: Use to tone down the bass sound.
–
(Control range from BASS 1 to BASS 6.)
÷ The volume level is displayed in the display window for 2 seconds.
Main unit
SUPER WOOFER
VOLUME
Note:
Because it is rotary, the VOLUME control knob and the SUPER WOOFER
VOLUME control knob do not have a volume stopper. Check the volume
level in the display window when adjusting.
ACTIVE CLEAR SOUND* button
Use the ACTIVE CLEAR SOUND (ACS) button to enhance the sound
reproduction. Press the ACTIVE CLEAR SOUND button to turn it ON/
OFF.
* Active Clear Sound (ACS)
The Active Clear Sound (ACS) circuit emphasizes high-frequency sound
without lowering the signal-noise ratio, while adjusting its output according
to the input signal level. This results in a better balance between the
high-frequency sound and the low-frequency heavy bass sound.
Main unit
ACTIVE
CLEAR SOUND
Lights when the ACS is ON.
12
Remote control unit
VOLUME
Remote control unit
SUPER WOOFER
VOLUME
Remote control unit
ACS
ACS
LEVEL
ON
Blinks depending on the volume level.
Sound mode button
Sound modes can be selected to enhance the type of music being played.
÷ Press the SOUND button to select the sound mode.
÷ Each time the SOUND button is pressed the sound mode changes as
follows:
Main unit Remote control unit
SOUND
SOUND
÷ The factory-preset is "FLAT". Each time the SOUND button is pressed, the
display changes as shown.
Sound mode selection
BEAT:
Set to this position for music with a heavy beat, such as rock or disco
music.
POP:
Set to this position for light music including popular and vocal music.
CLEAR:
Set to this position for crisp and clear sounding music with transparent
highs.
FLAT (No sound effect (flat characteristics)):
Set to this position when listening to classical music.
Note:
The selected modes only affect the sound output from the speakers or
headphones. They do not affect the sound when recording.