Using The Timers; Using Daily Timer - JVC MX-J500US Instructions Manual

Using the Timers

There are three timers available — Recording Timer, Daily
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake to your favorite music or
radio program.
How Daily Timer actually works
The unit automatically turns on, set the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the indicator flashes just before the on-
time, and continues flashing while the timer is operating).
Then, when the off-time comes ("OFF" flashes just before the
off-time), the unit automatically turns off (stands by).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press CLOCK/TIMER repeatedly
and start from step 1 again.)
Before you start...
• When using a CD as the source to play, make sure there
is a CD on the selected disc number tray.
• When using a tape as the source to play —
– Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
– Make sure that the tape direction is correct.
• When using the external component as the source to
play, set the timer equipped with the external component
at the same time.
On the unit ONLY:
1
Press CLOCK/TIMER until
"DAILY" appears on the display.
The DAILY (Daily Timer) indicator also starts
flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
ON TIME
DAILY
Canceled Clock
setting
(See page 9.)
REC
ON TIME
– 21 –
2
Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds, then the unit
enters on-time setting mode.
3
Set the on-time you want the
unit to turn on.
1) Press 4 or ¢ to set the hour,
then press SET.
2) Press 4 or ¢ to set the minute,
then press SET.
"OFF TIME" appears for 2 seconds,
then the unit enters off-time setting
mode.
4
Set the off-time you want the
unit to turn off (on standby).
1) Press 4 or ¢ to set the hour, then
press SET.
2) Press 4 or ¢ to set the minute,
then press SET.
The unit enters source selecting mode.
5
Press 4 or ¢ to select the
source to play, then press SET.
• Each time you press 4 or ¢, the
source changes as follows:
TUNER FM
AUX TAPE
TUNER FM: tunes into a specified preset
FM station. = go to step 6.
TUNER AM: tunes into a specified preset AM station.
= go to step 6.
– CD – –: plays a disc from a specified track of a
specified disc. = go to step 6.
TAPE: plays a tape in deck A or B. = go to step 7.
AUX: plays an external source. = go to step 7.
TUNER AM
– CD – –