Periodic Maintenance Procedures
Apply brake fluid to the cylinder bore.
Replace the fluid seal [A] with a new one.
Apply silicone grease to the fluid seal, and install it into
the cylinder by hand.
Replace the dust seal [B] with a new one if it is damaged.
Install the pad spring [A].
Apply silicone grease to the sleeve [B].
Install the rubber boot [C] and sleeve.
Install the pads (see Rear Brake Pad Installation in the
Wipe up any spilled brake fluid on the caliper with wet
Spark Plug Replacement
Remove the stick coils (see Stick Coil Removal in the
Electrical System chapter).
Remove the spark plugs using the 16 mm (0.63 in.) plug
wrench [A] vertically.
Replace the spark plug with a new one.
Standard Spark Plug
Insert the new spark plug in the plug hole, and finger
-tighten it first.
Using the plug wrench [A] vertically, tighten the plug.
The insulator of the spark plug may break if when
the wrench is inclined during tightening.
Torque - Spark Plugs: 13 N·m (1.3 kgf·m, 115 in·lb)
Install the stick coils securely.
Be sure the stick coils are installed by pulling up it lightly.
manuals search engine
PERIODIC MAINTENANCE 2-67