2-48 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Set the dimmer switch to high beam position.
The low beam [A] and high beam [B] headlights should
The high beam indicator light (LED) [C] should go on.
If the high beam headlight and/or high beam indicator light
(LED) does not go on, inspect or replace the following
Headlight High Beam Bulb (see Headlight Bulb Replace-
ment in the Electrical System chapter)
Dimmer Switch (see Switch Inspection in the Electrical
Turn off the engine stop switch.
The low beam and high beam headlights should stay go-
If the headlights and high beam indicator light (LED) does
go off, inspect or replace the following item.
Headlight Relay in Relay Box (see Relay Circuit Inspec-
tion in the Electrical System chapter)
Turn off the ignition switch.
The headlights and high beam indicator light (LED) should
Headlight Aiming Inspection
Inspect the headlight beam for aiming.
If the headlight beam points to one side rather than
straight ahead, adjust the horizontal beam.
Headlight Beam Horizontal Adjustment
Turn the horizontal adjuster [A] on the headlights in or out
until the beam points straight ahead.
If the headlight beam points too low or high, adjust the
Headlight Beam Vertical Adjustment
Turn the vertical adjuster [A] on the headlights in or out to
adjust the headlight vertically.
ON high beam, the brightest points should be slightly
below horizontal with the motorcycle on its wheels and
the rider seated. Adjust the headlight to the proper an-
gle according to local regulations.
manuals search engine