Meter, Gauge, Indicator Unit
Electronic Combination Meter Unit Inspection
•
Remove the meter unit [A].
[1] Left Turn Signal Indicator Light (LED) (+)
[2] Unused
[3] Unused
[4] Unused
[5] Unused
[6] Unused
[7] Water Temperature Sensor
[8] High Beam Indicator Light (LED)
[9] Right Turn Signal Light (LED) (+)
[10] Neutral Indicator Light (LED) Ground (–)
[11] ABS Indicator Light (LED) Ground (–) (Equipped
Models)
[12] Ground (–)
[13] Unused
[14] Battery (+)
[15] Ignition
[16] Fuel Level Sensor
[17] FI Indicator Light (LED) Ground (–)
[18] Speed Sensor Pulse
[19] Tachometer Pulse
[20] Oil Pressure Warning Indicator Light (LED) Ground
(–)
Do not drop the meter unit. Place the meter unit so
that it faces upward. If the meter unit is left upside
down or sideways for a long time or dropped, it will
malfunction. Do not short each terminals.
Check 1: Meter Unit Primary Operation Check
•
Using the auxiliary leads, the 12 V battery [A] to the meter
unit connector as follows.
○
Connect the battery positive (+) terminal to the terminal
[14].
○
Connect the battery negative (–) terminal to the terminal
[12].
•
Check that the tachometer needle [A] momentarily points
their last readings and back to the minimum position.
If the meter unit does not work, replace the meter assem-
bly.
Downloaded from
www.Manualslib.com
CAUTION
manuals search engine
ELECTRICAL SYSTEM 16-67
Comments to this Manuals
Latest comments: