Basic Settings; Setting The Clock; Setting The Display Illumination (Dimmer) - JVC FS-G6 Instructions Manual

Basic Settings

REMOTE CONTROL RM-SFSG6J
PANEL
DIMMER
OPEN/CLOSE
POWER
ACTIVE
SLEEP
BASS EX. CLOCK/TIMER
BASS TREBLE FM MODE
PLAY MODE REPEAT AUTO PRESET
TITTLE/EDIT ENTER
DISPLAY
/CHARA. CANCEL
UP
< >
SET
DOWN
MD AUX
Before operating the system any further, set the clock built
in this system first, then some other basic settings.

Setting the Clock

You can set the clock using the remote control whether
the system is turned on or turned off (i.e. standby mode).
1
Press CLOCK/TIMER button on the remote control.
The hour digit in the display window starts blinking.
2
Press < / > button on the remote control to adjust
the hour, then press SET button on the remote
control (rotating MULTI JOG dial also available).
• To correct the hour after pressing SET button, press
CANCEL button. The hour digit starts blinking again.
3
Press < / > button on the remote control to adjust
the minute, then press SET button on the remote
control (rotating MULTI JOG dial also available).
If there is a power failure
The clock loses the setting and is reset to "AM 12:00."
To adjust the clock again
You need to press CLOCK/TIMER button five times
until the clock setting mode is selected.
DIMMER
CLOCK/TIMER
MULTI JOG
SET
CANCEL
< / >

Setting the Display Illumination (Dimmer)

You can adjust the brightness of around the display window.
Each time you press DIMMER button, the display window
dims and brightens alternately.
• While the system is turned off:
• While the system is turned on:
POWER
STANDBY/ON
C O M P A C T C O M P O N E N T
FM/AM
MULTI JOG
MOS - FET
Display window
Press DIMMER button, "DISPLAY OFF" appears in the
display window for a while and the system clock
disappears.
Press the button again, "DISPLAY ON" appears in the
display window for a while and only the system clock
become dimmed.
Press DIMMER button, both operating information and
indicators in the display window dims. The light around
MULTI JOG dial also becomes darker than usual.
Press the button again, all the illumination around the
display window recovers as usual.
Dimmer setting in the standby mode
Once the system is turned on, the dimmer setting in
the standby mode does affect neither normal
operations nor display indications.
OPEN/CLOSE
S Y S T E M F S - G 6
AUX
VOLUME
10