Connecting Speakers - JVC FS-A52 Instructions Manual

Connecting Speakers

To connect speakers
You can connect the speakers by following the procedure
below:
1
2
Speaker terminals
SPEAKER IMPEDANCE
+
Speaker cord
R
–
R
Rear of the right
speaker
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity: White cord to (+) terminal and
black cord to (–) terminal.
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance—4 Ω to16 Ω.
3,4
MIN 4Ω
+
Speaker cord
L
–
L
Rear of the left
speaker
To remove the speaker grilles
The speaker grilles are removable.
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
– 8 –
Continued
Holes
Projections
Speaker grille