Korg pa 900 User Manual page 21

Professional arranger
Hide thumbs Also See for pa 900:
Table of Contents

Advertisement

STYLE CHANGE
This button turns the Style Change function on or off.
On
When you select a Performance, the Style might
change according to which Style is memorized
onto the Performance.
Off
When you select a Performance, the Style will
remain the same. Only Keyboard tracks (Sounds,
Effects...) will be changed.
Mic Setting Section
Use these buttons to check the audio input level, set the volume
of the microphone input and effects, and turn the microphone
and harmony voices on or off.
AUDIO IN LED
This LED shows the level of the audio signal entering the
AUDIO IN connectors (either mic or line). Three different col-
ors (green, orange, red) show the level. Try to keep the level so
that this LED remains on green most of the time, with orange
appearing at signal peaks. Never go to red.
Off:
No signal entering.
Green:
Low- to mid-level signal entering. If the LED
turns off too often, the input gain is too low.
When a microphone is connected to the LEFT
connector, use the MIC GAIN control to increase
the input level. When a line-level device is con-
nected, use the source device's own volume con-
trol.
Orange:
Slight overload in the signal path. This is fine if it
turns on only on signal peaks.
Red:
Clipping is occurring in the signal path. Use the
MIC GAIN control and/or the source device's
volume control to lower the input level.
See "AUDIO IN Section" on page 20 for more
information on the AUDIO IN connectors.
MIC VOLUME
Use this knob to set the overall volume of the microphone signal
(including the Voice Processor effects). This is equivalent to the
MIC/IN track you can see in the Volume pane of the main dis-
play.
FX LEVEL
Use this knob to set the volume of the Delay and Reverb sections
of the Voice Processor.
MIC ON/OFF
Press this button to turn the microphone input on or off. The
LED shows the status of the microphone section.
If you keep the SHIFT button pressed, and press this but-
tons, the Global > Mic > Global Setup page will appear (see
"Mic: Global Setup" on page 454).
HARMONY
Turns the Voice Harmony effect on or off. This adds harmoniza-
tion voices to the lead voice.
If you keep the SHIFT button pressed, and press this but-
ton, the Global > Mic > Harmony page will appear (see "Mic:
Harmony" on page 450).
PRESET
Use this button to open the Voice Processor Preset Select win-
dow and select a Preset to be assigned to the microphone signal
entering the LEFT input. This is the same as touching a Preset
name in the display.
For each type of Preset there are several Preset banks, that can be
selected by touching the side tabs. Each Preset bank may contain
up to eight Presets.
By keeping this button pressed for about one second, the
"Write Voice Processor Preset" dialog box will appear.
USB Host connector
Use this connector to connect USB mass storage devices.
USB HOST(F) CONNECTOR
This is a USB Type A (Master/Host) connector, USB 2.0 compli-
ant (High Speed). Use it to connect to the Pa900 an USB Flash
Memory stick, an external CD-ROM drive, an USB hard disk. To
access the connected device, go to the Media edit mode (see
"Media mode" on page 277).
Overview
17
Front Panel

Advertisement

Table of Contents
loading

Table of Contents