Adjusting The Volume: Speaker And Headphones - Canon VIXIA HV40 Instruction Manual

• During the playback of HDV recordings: Even
though their icons will appear on screen, the
following special playback modes are not
available.
- Reverse slow playback
- Frame reverse
- Double speed playback (forward or reverse)
• To protect the tape and video heads, the
camcorder will enter the stop mode (.) if left in
playback pause
(~II)
mode for 4 minutes 30
seconds. To resume the playback press
[~/II].
Adjusting the Volume: Speaker and
Headphones
The camcorder plays the sound with the
built-in speaker. When you're using the
viewfinder for playback, you can connect
a pair of headphones to listen to the
sound. You can also use the headphones
to check the audio level while recording.
Adjusting the Volume of the Speaker
([IJ 12)
- +
I~)t'dlldlllil
1
If the joystick guide does not appear
on screen, press <
8)
to display it.
2
Push the joystick <....
~
) toward
[±]
or
G
to adjust the volume.
• To turn off the volume completely,
keep pressing ( .... ) until the volume
icon changes to
I~~J.
• You can press
(8 )
again to hide the
joystick guide during playback.
Using Headphones
The headphones are connected to the
AV/O terminal, which is used for both the
headphones and the audio/video output.
Before connecting the headphones,
follow the procedure below to change the
function of the terminal from AV output to
o
(headphones) output and make sure
the
0
icon appears on the screen.
([IJ 12)
• Default value
~
PLAY/OUT SETUP2
.0.
I
AV/PHONES
I
AV
I
AV'
1
Press
[FUNC.].
2
Select < ~ ) the
ra
icon and press
(8)
to open the setup menus.
3
Select (""')
[~
PLAY/OUT
SETUP2]* and press
(8 ).
4
Select (""') [AV/PHONES] and
press (8).
5
Select <..
"')[0
PHONES] and press
(8). .