HP xw8600 Workstation Hardware Setup Manual page 22

Network Switch
Ports 3 and 4 to
additional panels
Autodesk Control Surface
NOTE The illustration shows the central panel only (the Colour Grading panel). This panel is easily identified,
since it has both an Ethernet network port and a USB connector. It is also the panel with the built-in tablet.
To connect the Autodesk Control Surface:
1 Connect each panel to a power supply using the AC power adapter cables.
2 Use network cables to connect each panel to the available ports in the network switch.
3 Additionally, connect the Colour Grading panel to the remote unit of the USB extender kit.
4 Use a network cable to connect an available port on the Netgear network switch to the workstation, as
illustrated.
18 | Chapter 3 Connecting Peripherals
To USB extender
NETGEAR
PWR
1
HP xw8600 Workstation
2 3 4 5 6 7 8
To port 1 on USB Extender
Autodesk
Tablet
5V DC 4A Ethernet
-
+