B-band UST Installation Manual page 12

Sidemount preamp with transducer
Table of Contents

Advertisement

The BASS TREBLE and PRESENCE tone controls are normal
boost / cut shelving controls.
The MIDDLE (midrange) tone control is a normal boost / cut
tone filter.
The center detent on these tone controls yields a flat tone re-
sponse. " +12 " boosts the tone; "-12" cuts the tone.
6. LOW BATT. (LOW BATTERY LED LIGHT)
The LED will light when the battery has lost power. Replace the
battery when this light is on.
This LED light will flash when a cable is connected to the out-
put jack of the pickup system. This shows the battery is good.
BATTERY
A 9-volt battery powers the B-Band A5T preamp. Before con-
necting the instrument to an amplifier or mixer please check
that a fully charged 9-volt battery is connected.
7. CHROMATIC TUNER
8. TUNER ON / OFF BUTTON
Note Readout Display
Flat LED
Sharp LED
In-Tune LED
Half Step LED
The tuner will work with or without a cable plugged into the
output jack.
Pushing the tuner button (8) turns ON the tuner. When the tuner
is active the pickup system output is muted. No sound will go to
the amplifier or mixer when the tuner is active.
Pushing the tuner button (8) again turns the tuner OFF and the
pickup system output will be active and sound will go to the
amplifier.
If the tuner is ON and the tuner button is not pushed within 2
minutes the tuner will turn OFF automatically and sound re-
turned to the output.
The tuner has a seven Note Readout Display; Half-step (#) LED;
Sharp arrow LED; Flat arrow LED and In-Tune LED.
The tuner Note Readout Display shows the nearest note of one
plucked string's sound. If the note showing is a half step (for
example A#; C#, D# and so), the half-step (#) LED will light.
If the Sharp LED is showing the string needs to be lowered in
pitch.
If the Flat LED is showing the string needs to be raised in pitch.
When the In-Tune LED lights the string is at the correct pitch of
the note displayed at the Note Readout Display.
SETTING UP THE PREAMP FOR USE
Tune the guitar. See the tuner instructions at 10 and 11.
Before plugging a cable into the guitar's output jack, turn the
volume control OFF ("0"), turn the 4-band EQ controls to the
middle position center detent (half way between "-12" and
"+12") and turn the tuner OFF.
Check that the 9-volt battery is good.
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

AstA3t

Table of Contents