Integrated Peripherals Setup - Intel VX PENTIUM PCI User Manual

3.7

INTEGRATED PERIPHERALS SETUP

The "INTEGRATED PERIPHERALS" is used to control the values of the I/O chipset
registers. These registers control the mode of HDD type and I/O address port.
Run the Integrated Peripherals as follows:
1. Choose "INTEGRATED PERIPHERALS" from the Main Menu and a screen with a
list of items appears.
IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
PCI Slot IDE 2nd Channel
USB Controller
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Onboard Parallel Mode
ECP Mode Use DMA
IDE Hard Disk Drive Mode Setting
The BIOS support two kind of methods to set up your IDE Hard Disk Drive Mode. One is
auto, the other is manual mode.
In auto mode BIOS can auto detect HDD's mode, but in some old type HDD that can't meet
ATA specification, the BIOS will detect wrong Mode and cause system boot fail. You must
change auto mode to manual mode and try a proper mode that can meet your HDD
specification. There are five modes defined in manual mode. They are mode 0,1,2,3,4. The
default setting for on board timing is auto mode that it will provide optimum performance for
your HDD.
ROM PCI / ISA BIOS (2A59GF51)
PCI/GREEN FUNCTION SETUP
AWARD SOFTWARE, INC.
: Enabled
: AUTO
: AUTO
: AUTO
: AUTO
: Enabled
: Enabled
: Enabled
: Disabled
: Enabled
: AUTO
: AUTO
: 378H/IRQ7
: ECP/EPP
: 3
ESC : Quit
F1 : Help
F5 : Old Values
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
BIOS Setup
↑↓ → ← : Select Item
PU/PD/+/- : Modify
(Shift) F2 : Color
Page 22