Application Rules - D-Link AC750 User Manual

Section 3 - Configuration
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and others.
These applications have difficulty working through NAT (Network Address Translation). Special Application Rules make some
of these applications work with the DIR-818LW. If you need to run applications that require multiple connections, specify the
port normally associated with an application in the Trigger Port field, select the protocol type as TCP or UDP, then enter the
Firewall (public) ports associated with the trigger port to open them for inbound traffic.
Enter a Name for the application rule. You may select a
Name:
pre-defined Application Name from the drop-down menu
and click << to populate the Name field.
This is the port used to trigger the application. It can be either
Trigger:
a single port or a range of ports.
Select the protocol of the Trigger port (TCP, UDP, or All).
Traffic Type:
This is the port number on the Internet side that will be used
Firewall:
to access the application. You may define a single port or a
range of ports. You can use a comma to add multiple ports
or port ranges.
Select the protocol of the Firewall port (TCP, UDP, or ALL).
Traffic Type:
The schedule of time when the Application Rule will be
Schedule:
enabled. The schedule may be set to Always, which will allow
the particular service to always be enabled. You can create your
own schedule in the Tools > Schedules section.
Click on Save Settings.
D-Link DIR-818LW User Manual

Application Rules

74