Connecting A Usb Mass Storage Class Device; Preparing The Remote Control; Canceling The Demonstration; Changing The Color System - JVC CA-DXJ21 Instructions Manual

Connecting a USB Mass storage class device

You can connect a USB mass storage class device such as a
USB flash memory, hard disk drive, multimedia card reader,
digital camera, etc. to this System.
USB cable
(not supplied)
Main unit
• You cannot connect a personal computer to the
MEMORY) terminal of the System.
• When connecting with a USB cable, use the USB 2.0 cable
whose length is less than 1 m (3.3 ft).

Preparing the Remote Control

Insert the batteries into the remote control by matching the
polarity (+ and –) correctly.
R6(SUM-3)/AA(15F)
When using the remote control, point the top of the
remote control toward the remote sensor as directly as
possible. If you operate it from a diagonal position, the
operating range (approx. 5 m/16.4 ft) may be shorter.
• If the range of effectiveness of the remote control decreases,
replace both batteries.
Caution:
Battery shall not be exposed to excessive heat such as
sunshine, fire or the like.

Canceling the Demonstration

2
sec.
To start the demonstration, select DEMO START.

Changing the Color System

(USB
You can select the video output to match it to the color
system of your TV (NTSC or PAL).
• You can change the setting only while playback is stopped.
1
Enter the color system setting mode.
2
Select the color system.
3
Store the setting.
Main Unit
ONLY
DEMO OFF
DEMO START
Remote
ONLY
2
sec.
INFO
6