Charts And Diagrams; Notes Of Schematic Diagram - JVC GR-D370UC Schematic Diagrams

NOTES OF SCHEMATIC DIAGRAM

Safety precautions
The Components indentified by the symbol
critical for safety. For continued safety, replace safety
critical components only with manufacturer's recom-
mended parts.
1. Units of components on the schematic diagram
Unless otherwise specified.
1) All resistance values are in ohm. 1/6 W, 1/8 W (refer to
parts list).
Chip resistors are 1/16 W.
K: KΩ(1000Ω), M: MΩ (1000KΩ)
2) All capacitance values are in µF, (P: PF).
3) All inductance values are in µH, (m: mH).
4) All diodes are 1SS133, MA165 or 1N4148M (refer to parts
list).
Note: The Parts Number, value and rated voltage etc. in
the Schematic Diagram are for references only.
When replacing the parts, refer to the Parts List.
2. Indications of control voltage
AUX : Active at high.
AUX or AUX(L) : Active at low.
3. Interpreting Connector indications
1
Removable connector
2
3
1
Wire soldered directly on board
2
3
1
Non-removable Board connector
2
3
1
2
Board to Board
3
4
Connected pattern on board
The arrows indicate signal path
Note: For the destination of each signal and further line
connections that are cut off from the diagram,
refer to "BOARD INTERCONNECTIONS"
2-1(No.YF124)

CHARTS AND DIAGRAMS

4. Voltage measurement
1) Regulator (DC/DC CONV) circuits
REC : Colour bar signal.
!
are
PB : Alignment tape (Colour bar).
—
2) Indication on schematic diagram
Voltage indications for REC and PB mode on the sche-
matic diagram are as shown below.
REC mode
Note: If the voltages are not indicated on the schematic
5. Signal path Symbols
The arrows indicate the signal path as follows.
NOTE : The arrow is DVC unique object.
6. Indication of the parts for adjustments
The parts for the adjustments are surrounded with the circle
as shown below.
7. Indication of the parts not mounted on the circuit board
"OPEN" is indicated by the parts not mounted on the circuit
board.
: Unmeasurable or unnecessary to measure.
1 2
2.5 1.8
(5.0)
PB and REC modes
(Voltage of PB and REC modes
PB mode
are the same)
diagram, refer to the voltage charts.
Playback signal path
Playback and recording signal path
Recording signal path
(including E-E signal path)
Capstan servo path
Drum servo path
(Example)
R-Y
Playback R-Y signal path
Y
Recording Y signal path
R216
OPEN
3