Mechanism Section Adjustments; How To Operate The Mechanism After The Cassette Compartment Is Removed; How To Load A Cassette Tape; How To Establish Record Mode - Sony CCD-TRV32 Service Manual

6-2. MECHANISM SECTION
ADJUSTMENTS
Refer to the separate "8 mm Video Mechanism Section Adjustment
Manual B Mechanism " for adjustment, check procedure and
mechanical parts replacement.
2-1. HOW TO OPERATE THE MECHANISM
AFTER THE CASSETTE COMPARTMENT IS
REMOVED

1. How to load a cassette tape:

1) Refer to "1. Disassembly" and turn the main power on with
the cabinet and camera section removed. (It enables to operate
the mechanical deck.)
2) Connect the adjustment remote commander and set the NORM
-ADJUST (HOLD) switch to ADJUST (ON) position.
3) Check that the main power is being supplied.
4) Select page : 6, address: 00, set data : 01 and press the PAUSE
button.
5) Select page : F, address: 02, set data : 01 and press the PAUSE
button.
6) Turn off the power supply once, then turn it on.
7) Set the NORM-ADJUST (HOLD) switch to NORM (OFF)
position. (The adjustment remote commander can be
disconnected hereafter.)
The pin which is fixed to
the pressed position of the
push-switch (3 keys).
(Other pins can be pressed
too.)
8) Press the push-switch-1 knob in the direction of arrow which
sets the machine into loading mode.
PB, FF/REW and CUE/REV operations are possible.
9) After completing all steps of above operation, be sure to perform

"4. Processing after operation".

2. How to establish RECORD mode:

1) Press pin of the push-switch 2 (ON state) and keep the ON
state by fixing with adhesive tape.
2) Turn the main power switch ON (select VTR or CAMERA
position of camera).
3) Set the RECORD switch to ON.
(When the test mode is selected, the rotation detection of the S
and T reel tables is muted, and the top end sensor is disable
which allow to run the tape.)

3. How to eject a cassette tape:

1) Press the EJECT switch to ON.
4. Processing after operation
1) Connect the adjustment remote commander and set the NORM
- ADJUST (HOLD) switch to ADJUST (ON) position.
2) Select page 6, address : 00, set data : 01 and press the PAUSE
button.
3) Select page: F, address : 02, set data : 00 and press the PAUSE
button.
4) Remove the power supply to the machine.
2 Push switch (3 keys)
6-47
3 Adhesive tape
1 Push-switch