Daikin ZQG71~140L7V1B Service Manual page 50

Wireless Remote Controller
DISPLAY "
TRANSMISSION)
1
This lights up when a signal is being
transmitted.
DISPLAY "
" " (OPERATION MODE)
2
This display shows the current OPER-
ATION MODE.
DISPLAY "
3
This display shows the set tempera-
ture.
DISPLAY "
(PROGRAMMED TIME)
4
This display shows PROGRAMMED
TIME of the system start or stop.
DISPLAY "
5
Refer to page 9.
DISPLAY " " " " " " (FAN SPEED)
6
The display shows the set fan speed.
DISPLAY "
(INSPECTION/ TEST OPERATION)
When the INSPECTION/TEST OPER-
7
ATION BUTTON is pressed, the display
shows the system mode is in.
Do not operate this button during nor-
mal use.
ON/OFF BUTTON
Press the button and the system will
8
start. Press the button again and the
system will stop.
FAN SPEED CONTROL BUTTON
Press this button to select the fan
9
speed, Low or Middle or High, of your
choice.
TEMPERATURE SETTING BUTTON
10
Use this button for SETTING TEMPER-
ATURE.
TEMPERATURE ADJUSTMENT/
PROGRAMMING TIMER BUTTON
Use this button for temperature setting
11
and programming "START and/or
STOP" time. (Operates with the front
cover of the remote controller opened.)
38
" (SIGNAL
" " " " " " "
H M L
" (SET TEMPERATURE)
C
"
hr. hr.
" (AIR FLOW FLAP)
"
TEST
TIMER MODE START/STOP BUTTON
12
Refer to page 10.
TIMER RESERVE/CANCEL BUTTON
13
Refer to page 11.
AIR FLOW DIRECTION ADJUST
BUTTON
14
Refer to page 9.
OPERATION MODE SELECTOR
BUTTON
Press this button to select OPERATION
15
MODE. " " (COOL), "
" " (AUTO), "
" " (DRY).
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE
16
in the operation manual attached to the
indoor unit.
INSPECTION/TEST OPERATION
BUTTON
17
This button is used only by qualified
service persons for maintenance
purposes.
EMERGENCY OPERATION SWITCH
18
This switch is readily used if the remote
controller does not work.
RECEIVER
19
This receives the signals from the
remote controller.
OPERATING INDICATOR LAMP
(Red)
20
This lamp stays lit while the air
conditioner runs. It flashes when the
unit is in trouble.
TIMER INDICATOR LAMP (Green)
21
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME
INDICATOR LAMP (Red)
22
Lights up when it is time to clean the air
filter.
DEFROST LAMP (Orange)
23
Lights up when the defrosting opera-
tion has started.
ESIE12-06
" (HEAT),
" (FAN),
3P107422-31W
Remote Controller