Parameter copy and parameter verification
4.29.2 Parameter verification
Whether same parameter values are set in other inverters or not can be checked.
Move the operation panel to the inverter to be verified.
1.
Move it during a stop.
Screen at power-ON
2.
The monitor display appears.
Parameter setting mode
3.
Press
to choose the parameter setting mode. (The parameter number read previously appears.).
Selecting the parameter number
4.
Turn
until "
appears.
Parameter verification
Turn
to change it to the setting value "
5.
Press
to read the parameter setting of the verified inverter to the operation panel. ("
If different parameters exist, different parameter numbers and "
Hold down
6.
If there is no difference, "
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
398
" (parameter copy) appears. Press
" (parameter copy verification mode).
to verify.
" and "
" flicker to complete verification.
Operation
to read the currently set value. "
" flicker.
" (initial value)
" flickers for about 30s.)