Tape Running Adjustment - Sharp VL-NZ50S Service Manual

7. TAPE RUNNING ADJUSTMENT

7-1. Adjustment locations
<Replacement parts>
· T roller, arm
· Tu guide, arm
· Slide chassis
<Replacement parts other
than those shown above>
· S guide
· Pole base
· Guide roller
· Drum assembly
· Capstan motor, etc.
7-2. Running height adjustment
· After replacement of T roller or Tu guide adjust the height . (Adjust only the replaced parts.)
· After height adjustment do not turn the T roller. If crease is found on the tape of Tu guide, remove the crease by rotating.
(As for details refer to the "Running rough adjustment".)
·
After height adjustment of T roller or Tu guide, apply Screw lock to an end of shaft.
(After replacement of S guide apply Screw lock to same point, too.)
Tu guide
Height setting
Master plane jig
7-3. Preparation for tape running adjustment
Meters, jig... Oscilloscope, Adjustment remote control, Height adjustment screw driver, Alignment tape (for tape running
adjustment, for switch point adjustment), Master plane, Height adjustment jig.
<Method and description>
(1) Clean the tape running surface (especially, adequately clean
the drum surface and the lower drum helicam surface).
(2) Attach the cassette controller.
(3) Connect an oscilloscope to each TP on the relay circuit board.
(4) Turn the AC adapter power ON.
(5) Using the adjustment remote control unit, put the system TEST
mode T-05.
(6) Replay the alignment tape for running adjustment, and make
sure that the tape is running in the SP mode.
(7) Check the oscilloscope playback envelope, then, at +1/4 shift
and -1/4 shift, check whether all of it is flat. If it is not, perform
the following adjustment so that it becomes flat.
(Each time you push the PLAY key, the shift will change;
+1/4 shift → Normal → -1/4 shift → Normal , in order.)
Adjust the height of only
replaced parts with the
adjusting jig.
Adjustment procedure 7-2
Cassette controller
installation
Height presetting is not
necessary.
Height setting
jig
Running adjustm-
ent preparation
Adjustment
procedure 7-3
T roller
Lower edge
fitting
Master plane
Sup guide roller
Tension roller
S guide
11
VL-NZ50S/H/E/W/NZ80H
VL-NZ100S/H/E
Running rough Running final
adjustment adjustment
Adjustment Adjustment
procedure 7-4 procedure 7-5
Height setting
jig
Master plane
Fit height the par on low edge fitting.
After setting adjustment jigs, turn T roller
counterclockwise to 315°.
Tu guide roller
Drum
Pinch roller
Reels
Tu guide