Rotary Encoder; Clutch Unit; Change Lever Assembly, Direct Gear, Clutch Gear And Coupling Gear - JVC HR-S9700EK Service Manual

Video cassette recorder
Hide thumbs Also See for HR-S9700EK:
Table of Contents

Advertisement

2.2.10 Rotary Encoder

1. How to remove
(1) Remove the screw (A) and remove the rotary encoder
by pulling it up. (See Fig. 2-2-10a.)
Rotary encoder (Front side)
Screw(A)
Guide marks
Rotary encoder (Back side)
Positioning pin of the rotary encoder
Fig. 2-2-10a
Mark E
Shaft of the rotary encoder guide
Control plate
Fig. 2-2-10b
2. How to install (Phase matching)
(1) Make sure that the mark E of the control plate is in align-
ment with the mark
of the loading arm gear shaft and
bring the guide marks on the rotary encoder into align-
ment as indicated in Fig.2-2-10a. (See Fig. 2-2-10a and
Fig. 2-2-10b.)
(2) Turn over the rotary encoder with its guide marks kept in
alignment and install it by fitting on the shaft of the rotary
encoder guide and the positioning pin.
(3) Tighten the screw (A) to complete the installation.

2.2.11 Clutch Unit

(1) Remove the belt wound around the capstan motor and
the clutch unit.
(2) Remove the slit washer and remove the clutch unit.
Belt
Slit washer
Clutch unit
Fig. 2-2-11a
2.2.12 Change Lever Assembly, Direct Gear, Clutch
Gear and Coupling Gear
1. How to remove
(1) Release the two lugs of the rotary encoder guide in the
arrow-indicated direction and remove the change lever
assembly.
(2) Remove the slit washer retaining the direct gear and re-
move the latter.
Take care so as not to lose the washer and spring. (See
Fig.2-2-12a.)
Slit washer
Change lever
assembly
Washer (
1)
*
Spacer
Direct gear
Spring(A)
Clutch gear
Position the projecting
side down.
Spring(B)
Spring (C)
Spacer (
1)
*
Coupling gear (
2)
*
Lugs
Note:
• The parts with marked (
) have different types of mechanisms (standard type or high-
*
speed FF/REW type).
1 : Uses the standard type mechanism only.
*
2 : Uses the high-speed FF/REW type mechanism only.
*
Fig. 2-2-12a
2. How to install
(1) Install the clutch gear, spring (A), spring (C), direct gear,
spacer and others to the individual shafts of the main
deck, and finally the slit washer. (See Fig.2-2-12a.)
(2) Let the spring (B) drops into the rotary encoder guide hole
and install the change lever assembly.(Take care not to
mistake a direction of the spring.) The point is to slightly
lift the clutch gear and catch it from the both sides with
the assembly. (See Fig.2-2-12b.)
Rotary encoder guide
Change lever assembly
Spring(B)
Clutch gear
Main deck
Main deck
Fig. 2-2-12b
2-10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hr-s9700eu

Table of Contents