Pioneer PDP-502MX Service Manual page 71

3.Removing and installing Front Protection Panel
1) Remove all 30 screws E: BPZ30P080FZK that fixes Panel
Holder V and Panel Holder Assy to Front Case.
2) Remove Front Protection Panel and replace it.
3) Install Front Protection Panel by attaching to the bottom left
side first, and then attach a Corner Cushion to each corner (only
bottom left side, attach a Corner Gasket).
Note) When new Front Protection Panel is installed, Front Cushion
H and Front Cushion V attached to Front Case are not needed
to be replaced.
4) Assemble Front Case in the opposite order of disassembling it.
Mount Panel Holder Assy first, then mount Panel Holder V.
Panel Cushion V
×5
E
Panel Holder V
Corner
Cushion
Panel Cushion H
Panel Holder Assy
Note)
Attach Panel Cushion V along the base of bending line of Panel
Holder V, and attach Panel Cushion H along the edge of Panel
Holder Assy like shown in Figure 3.
Panel Holder V / Panel Shield V and Panel Holder Assy / Panel
Shield H are inlaid fixed structures.
Be careful not to lose Remote Receiver lens, because it is not
fixed to any where after removing Panel Holder Assy.
Panel Cushion H
Panel Holder Assy
How to attach Panel Cushions
Panel Cushion H
Corner
Cushion
Front Protection Panel
Corner
Cushion
×10
E
Front Case
PDP-502MX, PDP-502MXE
Panel Cushion V
Place it along the base
Place it along
of bending line
the edge
Panel Holder V
In this two corners,
do not put the Panel
cushion on the other
one.
E
Corner
Cushion
Panel Cushion V
×5
E
Panel Holder V
×10
Panel Holder
Assy
71