General; Step 1: Installing The Projection Tv; Step 2: Hookup - Sony KP-48V75 Service Manual

Getting Started
Step 1: Installing
the projection TV
For the best picture quality, install the projection TV
within the areas shown below.
Optimum viewing area (Horizontal)
60°
60° 60¡
Optimum viewing area (Vertical)
20°
20°
SECTION 1

GENERAL

Carrying your projection TV
p KP-48V75/53V75 only
Be sure to grasp the areas indicated when carrying the
projection TV, and to use more than two people.
(Rear of projection TV)
p KP-61V75 only
Carry your projection TV by the casters.
Preparing for your projection TV
Before you use your projection TV, adjust convergence.
For the procedure, see "Step 4: Setting up the projection
TV automatically (AUTO SET UP)" on page 21.
5 -EN
Getting Started
The operating instructions mentioned here partial abstracts from the
Operating Instructions Manual. The page numbers of the Operating
Instruction Manual remain as in the manual.(part.no : 3-862-729-11)

Step 2: Hookup

Although you can use either an indoor or outdoor
antenna with your projection TV, we recommend that
you connect an outdoor antenna or a cable TV system
to get better picture quality.
Connecting an antenna
Connect your antenna cable to the VHF/UHF antenna
terminal. If you cannot connect your antenna cable
directly to the terminal, follow one of the instructions
below depending on your cable type.
EN
(Rear of projection TV)
A
75-ohm coaxial cable
• VHF only
or
• VHF/UHF
or
• Cable
(Rear of projection TV)
B
300-ohm twin lead cable
• VHF only
or
• UHF only
or
Antenna connector
• VHF/UHF
75-ohm coaxial cable
C
• VHF
(Rear of projection TV)
and
EAC-66 U/V mixer
(not supplied)
• UHF
300-ohm twin lead cable
Notes
• Most VHF/UHF combination antennas have a signal splitter.
Remove the splitter before attaching the appropriate connector.
• If you use the U/V mixer, snow and noise may appear in the
picture when viewing cable TV channels over 37.
6 -EN
Getting Started
Connecting an antenna/cable TV
system without a VCR
To cable or antenna
(Rear of projection TV)
Cable
To cable box
If your cable company requires you to connect a cable
box, make the connection as follows:
(Rear of projection TV)
Cable
IN OUT
Cable box
To cable box and cable
(Rear of projection TV)
Cable box
VHF/UHF
75-ohm coaxial
cable (not supplied)
CATV cable
VHF/UHF
Pay cable TV systems use scrambled or encoded signals
requiring a cable box* in addition to the normal cable
connection.
* The cable box will be supplied by the cable company.
Note
VHF/UHF
• You cannot watch the signal through an AUX connector as a
window picture.
To cable and antenna
(Rear of projection TV)
CATV cable
Antenna cable
Note
• Do not connect anything to the TO CONVERTER connector in
this case.
VHF/UHF
VHF/UHF
AUX
TO
CONVERTER
VHF/UHF
AUX
TO
CONVERTER
VHF/UHF