Umid Output And Display; Umid Output Settings; Umid Display - Sony MSW-A2000 Operation Manual

8-3 UMID Output and Display

8-1 Overview of UMID Functions
This section explains how to output and display
UMIDs.

8-3-1 UMID Output Settings

You can choose whether or not to output UMIDs
superimposed on SDI signals, and select either Basic
UMID or Extended UMID when you choose to output
UMIDs. Make these settings using setup menu item
651 UMID OUTPUT.
See page 12-20 for more information about setup menu item
651.

8-3-2 UMID Display

During recording and playback, UMID data appears in
the menu display section of the control panel and on
the video monitor.
To display the UMID
In function menu page 5, press the F2 (UMID) button.
See Section 11-1-2 "Using the Function Menu" (page 11-2)
for more information about function menu operations.
The UMID appears in the menu display section of the
control panel and on the video monitor.
First item in UMID displayed in menu display section
UMI INSTANCE 24PRS XX-XX-XX
D
HOME F1 F2 F3
See the next section "UMID display on the video monitor"
for examples of the UMID displayed on the video monitor.
To switch the displayed UMID item in the
menu display section
Rotate the MULTI CONTROL knob.
To exit from UMID display
Press the F6 (EXIT) button.
8-4
Chapter 8 UMID Functions
EXIT
F4 F5 F6
UMID display on the video monitor
The video monitor connected to the COMPOSITE
VIDEO OUTPUT 3(SUPER) connector or the SDI
OUTPUT 3(SUPER) connector on the connector panel
displays all UMID items at once. The display of each
line is explained below.
UMID INFORMATION
INSTANCE 24PRS XX-XX-XX
MATERIAL IEEE 1394 ZONE
XX-XX-XX-XX-XX-XX-XX-XX
XX-XX-XX-XX-XX-XX-XX-XX
DATE/TIME 20XX/XX/XX
XX:XX:XX:XX +XX:XX
ALTITUDE XXXXXXXXm
LONGITUDE EXXX XX'XX.XX
LATITUDE SXXX XX'XX.XX
ORGANIZATION XXXX
USER XXXX COUNTRY XXXX
1 Instance Number generation method and
Instance Number
The generation method is displayed as follows.
CP+16: "16-bit PRS (pseudo-random sequence)
+Copy No." method
24PRS: 24-bit PRS method
others: Other than the above
2 Material Number generation method
SMPTE: SMPTE method
IEEE 1394 ZONE: IEEE 1394 ZONE method
IEEE 1394 RND: IEEE 1394 RND method
others: Other than the above
3 Material Number
The material number is displayed in hexadecimal
across two lines.
The following items, 4 through 9, are contained in
the Source Pack.
4 Date/Time
Date/Time data is displayed across two lines.
The upper line shows the MJD (Modified Julian Date)
contained in the Source Pack, converted to the
christian era.
The lower line shows the data in unit count format
(hours : minutes : seconds : frame) converted to UTC.
1
2
3
4
5
6
7
8
9