Accessing Call Information - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Accessing call information

A call state indicator is available in the top bar in the web
interface. It shows whether the system is in a call or not. You
may also be notified about incoming calls.
D15106.02 SX10 Quick Set Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface Web interface
Incoming call notification
As default, a notification is given when the
system receives a call.
Check this box, if you do not want to receive
such notifications.
Opening the Call Control page
Click Open Call Control
System settings
to go straight to the Call Control page.
22
Administrator Guide
Setting passwords
Call state indicator
The call state indicator is
available on all pages except
the
The badge indicates the number
of active calls. If the system is
idle, there is no badge.
Click the indicator to get more
details about connected calls.
Use these buttons to:
•
•
•
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
Appendices
Call Control page.
Call control
Show call details
Put the call on hold
Disconnect the call