Table of Contents
Advertisement
Adjustment items
Focus adjustment
The items of G lens adjust-
ment mentionedin 4) are
applicable to 50PH, 61PH,
50W, and 57W, and regarding
the G lens adjustment for
43PH and 42W, apply the
methods mentioned in the
next page.
(Conditions)
- User adjustment: Dynamic mode, Cinema mode
- To be performed after centering magnet adjustment.
- Signal :
Lens: R .... Retma Pattern (PAL)
G .... Crosshatch (PAL)
B .... Crosshatch (PAL)
Electrical focus :
R .... Retma Pattern (PAL)
G .... Crosshatch (PAL)
B .... RetmaPattern (PAL)
(Adjustment)
1. Common item
1) Make coarse adjustments in advance on the lens focus and electrical
focus of each R, G, and B tube.
2. G adjustment
1) Set to the G monochrome by lens cap.
2) Receive the image of crosshatch.
3) Adjust the G electric focus.
Adjust the G electrical focus by the focus volume of focus block (Z410)
so that the screen center will come to optimum focus. (Although the G
electrical focus is to be adjusted to allow the scanning lines in the center
of the screen to be seen most clealy, if G alignment and astigmatism are
inferior with the appearance of vertical and horizontal flares in the center
of and around the screen and if the lines become thicker, adjust to the
best point observing the entire screen.)
4) Adjust the G lens focus. (Details on43PH and 42W are mentioned in the
next page)
Keep an eye on the center of the crosshatch pattern and adjust so that
the screen center will become clear.
As a rough guide to decrease unevenness, adjust so that red flares on
both sides of the crosshatch line will come to 1mm in thickness.
5) Repeat 4, 5, and attempt to further improve the focus quality.
– 16 –
Adjusting methods
Advertisement
Table of Contents
