Troubleshooting For Anynet - Samsung 850 User Manual

I want to start Anynet+.
The connected device is not
displayed.
The message Connecting to
Anynet+ device... appears on the
screen.
I
' , . .
Troubleshooting for Anynet+
.~~ I~~'
'
Anynet+ does not work.
I •
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
I
devices only.
• Connect only one receiver (home theater).
• Check if the Anynet+ device power cord is properly connected.
,
• Check the Anynet+ device's Video/Audio/HOM I 1.3 cable connections.
• Check whether Anynet+ (HOMI-CEC) is set to On in the Anynet+ setup menu.
• Check whether the TV remote control is in TV mode.
I·
Check whether it is Anynet+ exclusive remote control.
• Anynet+ doesn't work in certain situations. (Searching channels, Operating
WISELINK Pro, Plug & Play, etc.)
• When connecting or removing the HOMI 1.3 cable, please make sure to search
! devices again or turn your TV off and on again.
i •
Check if the Anynet+ Function of Anynet+ device is set on.
--~I·
- - - - -
I•
Check if the Anynet+ device is properly connected to the TV and check if the
i
Anynet+ (HOMI-CEC) is set to On in the Anynet+ Setup menu.
I • Press the TV button on the TV remote control to switch to TV. Then press the
1~~~t;~;;;jAnYn;~----tt:;:~~~~~;~~;:~t:~::::t~~~=~~=--
I
than Anynet+ devices.
I· Press CH, CH LIST, PRE-CH, and FAV.CH to change the TV mode.
'I'
(Note that the channel button operates only when a tuner-embedded Anynet+
device is not connected.)
- - - - - - - - - - - - - -
I • You cannot use the remote control when you are configuring Anynet+ or
II
switching to a view mode.
• Use the remote control when the Anynet+ setting or switching to view mode is
I
complete.
The Anynet+ device does not play.
I
You cannot use the play function when Plug & Play is in progress.
I.
Check whether or not the device supports Anynet+ functions.
I·
Check whether or not the HOMI 1.3 cable is properly connected.
I·
Check whether Anynet+ (HOMI-CEC) is set to On in the Anynet+ setup menu.
I·
Search Anynet+ devices again.
I·
You can connect an Anynet+ device using the HOMI 1.3 cable only. Some HOMI
cables may not support Anynet+ functions.
• If it is terminated by an abnormal situation such as disconnecting the HOMI cable
or power cord or a power failure, please repeat the device scan.
- - - - - - - -
The TV program cannot be Check whether the antenna jack on the recording device is properly connected.
recorded.
I
-----_._------------j--
The TV sound is not output
li
C onnect the optical cable between TV and the receiver.
through the receiver.
- , - - -
._-- -