6.1.14 Ink Cartridge Support Base, Ink Absorber Case, Ink Slot Cover, and Air Pump & Motor Module
(1) Remove the four screws from the ink cartridge support base and lift it off the lower cover.
(2) Remove the two screws from the ink absorber case and take it out of the lower cover.
NOTE: Do not remove the ink absorber case unless it needs to be replaced. When replacing it,
set a new one immediately to prevent the machine from getting stained with drained ink.
NOTE: If the ink absorber case or its surroundings are stained with ink, wipe it off with a cloth.
Ink cartridge
sensor harness
Ink absorber case
6-41
Taptite, cup B M3x10
Ink cartridge support base
Lower cover