Animas OneTouch Ping Owner's Booklet page 173

CHAPTER 7 - FASTFACTS
Downloading meter remote logbook records to a PC
It's important to save the data in your meter remote memory on a regular basis. Your meter remote
memory will store at least 20,000 records but will eventually fill up if you do not transfer the data to a
PC and/or other storage device. If your meter remote memory becomes full, the oldest records will be
replaced by the newest records as they are created. You can use your meter remote with ezManager
Software (provided with your pump) for storing your records, and to help you spot patterns for planning
meals, exercise, and medication. ezManager
remote into charts and graphs.
Transferring BG test results to your PC for storage or home viewing requires ezManager
®
Animas and a USB 2.0 compliant Type 'A' to Mini 'B' Interface Cable. The USB Interface Cable is
included with your OneTouch
NOTE: To ensure safe operation of your meter remote when connecting it to a PC, the computer must
have an appropriate safety approval as indicated by the presence of one or more of the following logos
(UL, CSA, or CE) on the PC or monitor. Also check to see if the PC is connected correctly to its power
source.
WARNING:
• Electrostatic discharge (ESD) can build up when it's very dry and/or while you are wearing
certain synthetic clothing. To reduce ESD build-up and possible damage to your meter remote,
first touch a grounded metal surface (such as a doorknob) before connecting your meter
remote to a PC with the USB Cable.
• To avoid a possible shock, Do Not insert a test strip or change the batteries when your meter
remote is connected to a PC with the USB Cable.
1
Install the software on your PC
Follow the installation instructions provided with ezManager
2
Get ready to transfer readings
Connect the Type 'A' end of the USB Cable to a USB port on your PC. With
your meter remote turned on, connect the Mini 'B' end of the USB Cable to
the data port located on the lower left side of your meter remote. Be sure
the Mini 'B' plug is inserted all the way.
After you plug the USB Cable into the data port, "PC" will appear on your
meter display. This indicates that your meter remote is in communication
mode. You will not be able to perform a test when your meter remote is in
communication mode.
If the data transfer command is not received within one minute, your meter
remote will turn itself off. Press the
® / USING YOUR METER REMOTE LOGBOOK
® Software puts information downloaded from your meter
® ™
Ping System Kit.
button to turn the meter back on.
157
®
Software.
®
® Software from
PC