[6-3 Making the Group and Interlock Settings from an ME Remote Controller ]
To search for the address of indoor units that have been entered into
the remote controller, follow steps
(A) To search group settings
Bring up the Group Setting window.
- Each pressing of button
[TIMER ] will bring up the address of a
registered indoor unit and its unit type on the display.
<No entries found>
- When only one unit address is registered, the same address
will remain on the display regardless of how many times the
button is pressed.
- When the address of multiple units are registered
(i.e. 011, 012, 013 ), they will be displayed one at a time in
an ascending order with each pressing of button
To go back to the normal display,
(Indoor unit in this case)
[TIMER ] .
To delete an address, go to
section 6-3-4 "Address Deletion."
(B) Interlock setting search
After performing step
, proceed as follows:
Bring up the address of the indoor unit to be searched on
- Select the address of the indoor unit to be searched by pressing
[TIMER SET (
through the interlocked addresses.
LOSSNAY can be searched in the same manner by bringing up
the LOSSNAY address in the Interlocked unit address display window.
Bring up on the display the address of the LOSSNAY unit
that was interlocked with the indoor unit in step
- With each pressing of button
LOSSNAY and indoor unit that is interlocked with it will be
Address of an interlocked
Bring up the address of another registered unit on the
- After completing step
[TIMER] will bring up the address of another registered
(The display method is the same as the one in step
Address of another
- 153 -
) or (
)] to advance or go back
[TIMER], the address of the
, a subsequent pressing of button
Refer to section 6-3-4 "Address Deletion"
for how to delete an address.