[5-1 Dipswitch Functions and Factory Settings ]
(2) ME remote controller (PAR-F27MEA-US)
Set the address of the remote controller with the rotary switch.
Main remote controller
Sub remote controller
Setting of rotary switch
*1. At factory shipment, the rotary switch is set to 01.
*2. The address range that can be set with the ME remote controller is between 101 and 200. When the dials are set to
a number between 01 and 99, the 100's digit is automatically set to . When the dials are set to 00, the 100's digit is
automatically set to .
To set addresses, use a precision slotted screw driver [2.0 mm [0.08 in] (w)], and do not apply than 19.6N.
The use of any other tool or applying too much load may damage the switch.
BC Controller Switch Settings
2 - 5
No. of ports
1 - 6
Remote controller unit
Example: In case of address 108
Address setting range
101-199 with the 100's digit automatically being set to 1
Function according to switch setting
- 123 -
10's digit 1's digit
Add 100 to the smallest address of all the indoor units in the
Add 150 to the smallest address of all the indoor units in the
Always leave this switch to OFF.
Before being energized
Switch setting timing